HiQSDR-Case

From HiQSDR
Jump to: navigation, search

HiQSDR shielded case

To protect the HiQSDR, use a shielded case that is 102 mm wide, 112 mm long and 30 mm high.
This case can be built using a standard EU tinplate case 102mmx162mmx30mm from Otto Schubert Gehaeuse No.11
The side panels and the top cover need to be shortened. A cover is required only on the top.
On the bottom side, the heat spreader from the ultra low noise supply should be mounted on a heat sink.


Mechanical Drawing of SMA and RJ45 connector as PDF
Mechanical Drawing of preselector ribbon cable panel cut-out as PDF
Mechanical Drawing of power and external control panel cut-out as PDF

Positions of the holes to mount the HiQSDR to a heat sink or a plate.
Print out the drawing in full size - this makes it easier to transfer the holes.

Mechanical Drawing showing the positions of the holes as PDF

Personal tools
Namespaces

Variants
Actions
HiQSDR
HiQSDR Board
RF Bridge
HiQSDR Preselector Board
HiQSDR 10 Enclosure
HiQSDR MPPA Amplifier
Under Development
HiQSDR Maker Site's
Exhibitions
Navigation
Toolbox
Translate